Set up your wheel by arranging the CraftlaceTM according to Pattern A. Make sure the CraftlaceTM strands stay flat. Once the strands are secure on the wheel you can begin making a lanyard.
1. Start with #32 on top and #16 on the bottom.
2. You will start with the strands on either side of #16 (bottom of wheel).
3. Always start with the bottom left strand.
4. Pull out lace between 16 & 17 go straight across the wheel and insert between 30 & 31. You will now have three strands on top: left, middle and right.
5. Pull out lace between 1 & 32 and insert across the wheel between 14 & 15.
6. Turn the wheel counterclockwise to the next dot. When you turn the wheel, the top and bottom numbers will change. Dots indicate top and bottom of wheel. With your first turn #8 will be on top, #24 on the bottom.
7. Repeat steps 4-7* until the desired length is reached. *Always bring the furthest left bottom strand UP and across to the top of the wheel and insert it to the left of the two top strands. The top right strand will always come DOWN and across inserted to the right of the bottom strand.
8. When you reach your desired length, remove your lanyard from the wheel. Tie a basic knot on the end of your lanyard and clip the tail to desired length.
1. Tie the laces in a knot around the pencil 3" from the point. Wrap both strands tightly up and around the pencil and tie in a knot at the top (eraser end).
2. Add 7 pony beads onto each strand of lace, and tie off each end with two overhand knots to hold in place; trim lace.
1. Tie the laces in a knot around the pencil 3" from the point. Secure the pencil to a clip board.
2. Braid the three strands of lace, then wrap the braid tightly up and around the pencil and tie in a knot at the top (eraser end).
3. Add 1 pony bead onto the lace, braid three repeats, add the second bead, braid three more repeats, add the third bead and tie off lace ends with two overhand knots to hold in place; trim lace
1. Tie the lace in a knot around the pencil 3" from the point. Wrap the lace tightly up and around the pencil and tie in a knot at the top (eraser end).
2. Add 10 pony beads onto the end of the lace, and tie off with two overhand knots to hold in place; trim lace.
1. Remove the end of the gel pen and insert the ends of the laces into the pen; replace end of pen to secure.
2. Wrap the strands of lace tightly around the pen, ending 1-1/2" from the tip, and tie in a knot around the pen.
3. Braid the remainder of the lace to make a 22" long necklace; tie off loop with two overhand knots. Add pony beads and tie two overhand knots. Trim ends of lace.
1. Twist two colors of wire together, from into a large flat spiral. Repeat with three other color combinations for a total of four spirals. Wire the spirals together in a column and clip away ends.
Large seed beads, rocailles and E beads recommended
Instructions:
1. Wrap wire tightly around the part of the pin that doesn't unhook from the head. After a few wraps to secure it, add beads and either continue wrapping and twisting around the pin, or finish the end of the wire in a spiral or coil and start a new wire wrap on the pin.
